- Fuel oil ratio for apc mini bike chopper install#
- Fuel oil ratio for apc mini bike chopper generator#
- Fuel oil ratio for apc mini bike chopper zip#
Fuel oil ratio for apc mini bike chopper zip#
Use some tin snips to cut cover at the rear if needed.Use a good zip tie at the rear and the extra long bolt for the counter shaft cover will hold the front. Make sure you grease the plastic wheel metal shaft.
Fuel oil ratio for apc mini bike chopper install#
Do not cut chain too short !! Install Idler pulley. Put some molly grease on the shaft and in the hole.Ĭut chain to length and using master link put chain back together.
![fuel oil ratio for apc mini bike chopper fuel oil ratio for apc mini bike chopper](https://motocrossactionmag.com/wp-content/uploads/2019/04/TWO-STROKE-premix-ratio-chart.jpg)
Tip.Since you have this cover off, Hold clutch arm and rotate cover and pull clutch arm out of cover and then grease it and rotate it back in. Having the spark plug removed allows engine to be turned easily to thread chain. Remove clip from master link of chain and then thread chain up and over counter shaft sprocket by rotating the sprocket using tool. Remove the 3 screws from Counter shaft side cover and also remove spark plug. Anything that draws more current connected to the white wire will kill the motor.
Fuel oil ratio for apc mini bike chopper generator#
The white wire is generator and has a max output of. Also.Tie Kill Switch to the Blue wire / earth. It is not hard the break the coil ears off using the screws.Wire Connections.Blue to Blue and Black To Black. You will have a more solid mount and not break the coil. This is a better method than using the screws that come with the kit. Loop one zip tie up and over and also through the holes that would normally have the screws going through them. Go up and over and around the coil and zip tie it to the frame. Apply plumbers tape to thread if leaking. Also.If you have cable runs on the top bar that are open cables, you may need to run them through cable sheath the length of the tank in order for them to work once tank is clamped over them. Tip.Wrap top frame tube with bar wrap where tank clamps are. Screw in the fuel valve filter combo into the tank and then mount the tank. If you get real ambitious, unload cable from carb slide and from throttle end and clean up the fiber plastic and lube the cable sheath and re assemble. Slide throttle on all the way and then back it off a hair and then tighten it down evenly.
![fuel oil ratio for apc mini bike chopper fuel oil ratio for apc mini bike chopper](https://static.wixstatic.com/media/4c4ad3_1983a6e737ce43a38a1e6838a1d24dc8~mv2_d_1500_1500_s_2.png)
Lightly grease right side handle bar end. Also, you may need to file down any water bottle screw mounts if they protrude and are in the way of a motor mount. If you use the spacer on the front motor mount, usually this is enough to clear. I used this method.Īlways mount air intake with inlets down!! Always!! If you need to, you can put the air box on a grinder and cut down on the inlet tubes a little to make sure they clear the frame. My bike had an ovoid shaped lower bar about 50mm across. Then, you can use the steel motor mount clamp that came with the kit and not have to drill a hole in your frame. I prefer the method shown, which is to pull the studs and replace them with longer ones (threaded rod) that you can get at the local hardware store. This spacer normally would require the drilling of a hole in the frame to bolt the centre of the spacer through (shown below). Use spacer provided with the kit (spacer bar is not included in the some kit). Some bikes have a large diameter lower bar and some need clearance for the air box intake so you need to use the parts provided in the kit.